Place
the microscope on a stable place are Laboratory bench . always sit straight
while working with the microscope . place the microscope near the window if
daylight is used for illumination
2)
Direct
the path of right to pass through the hole of the stage while setting the
mirror
3)
Put
the slide between the clips provided on the stage.
4)
Revolve
the nose piece and aligen the low power objective clox two examination the object on the slide. The
objective must into click into place
5)
Adjust
the illumination to improve contrast.
6)
Put
one hand on the focusing knob are fine one set time and the other on the screw to move the stage.
Use the adjustment knob for bringing the object closed two focus with the fine adjustment knob.
7)
Switch
to high power 40x and increase the illumination as needed. Bring the object of
interest in the centers as the use of fine adjustment knob may not be critical
and switched freely.
8)
If
high power Leans tends to touch a thick slide are slide with cover slip, always
focus by the anti clock wise movements. Of the coarse adjustment knob.
9)
After
screening under the low power and examination under the high power , oil
immersion objective is used for greeter details of the object. A tiny drop of immersion oil is applied on the place
where object and the reset will come over the path of light and the oil immersion objective.